Упражнения по теме “Modal Verbs” Copy

Any quantity of material be burnt or missing if it has not gone all the way through the platform.

Do not clean plastic and rubber-base materials with stoddard solvent. Corrosion of materials occur.

Printout of the maintenance data recorder tape provide valuable additional data and indication of system malfunction.

No part of the seal teeth be visible.

Oil jet out from nozzle be smooth and steady stream while you pump the oil in.

Damage more than the limits be blended to be permitted.

The engine is designed so that large subassemblies be removed, exchanged, and installed separately.

You disassemble the engine to do this task.

Damage be contained in Area A. Up to four blades may be damaged. All other restrictions of Maximum Serviceable Limits for their condition apply.

A wire harness or fire detector fault be intermittent because of the engine temperature.

Any drilling of holes or trimming of the placard be performed prior to installation.

Push and release the MEM READ switch again and the display be blank.

One crack is permitted. Its length be less than the distance between eight gill holes or 0.90 inch (22.86 mm).

If you loosen and remove the referenced borescope plug, you do the borescope inspection through an adjacent port.

The melted ash has very high adhesive qualities and bonds to engine parts and thus decreases engine performance. It   obstruct the fuel injectors and  cause an engine shutdown.

Due to similarity of design, this condition  also affect other P/N fire extinguishers.

This condition, if not corrected,  lead to galley / trolley detachment and collapse into an adjacent cabin aisle or cabin zone.

The installation  be accomplished in accordance with aeroplane modification instructions approved by EASA, or approved under Airbus DOA.

This approach  make it easier for an operator to comply with the requirements of this AD without the need for AMOCs to install future acceptable part numbers and still prevent unsafe parts from being installed.