0 of 65 questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Time has elapsed
Выберете правильный вариант на место пробела.
Treat _____ reworked surfaces in accordance with TM 43-0105.
Выберете правильный вариант на место пробела.
You can repair 5 linear inches (127 mm) of _____ bad adhesive bond.
Выберете правильный вариант на место пробела.
This would be _____ alternative to the normal procedure.
Выберете правильный вариант на место пробела.
Make _____ Analysis of the data.
Выберите правильный вариант.
Push the two test toggle _____ to the TEST position.
Выберите правильный вариант.
MEK is a poisonous and flammable solvent which can cause _____ to persons and damage to equipment.
Выберите правильный вариант.
Install the borescope plugs in the borescope _____.
Выберите правильный вариант.
This task provides the instructions on how to do a borescope inspection of the oil system for leakage that resulted in oil _____ in the cabin air system.
Выберите правильный вариант.
There are two main landing gear _____ installed on the aircraft.
Выберите правильный вариант.
The basic or standard storage arrangement is the traditional array of storage _____ or bins, marked by a coordinate system so that every part has a location and each location is easily found.
Выберите правильный вариант.
If you use a hand held cleaning wand, make sure that you aim the wand at the inlet to the LPC and approximately 5 to 10 _____ from the engine inlet.
Выберите правильный вариант.
After ten _____, flush the engine with water.
Выберите правильный вариант.
Attach the single cable to _____ connections:
<1> P8 HARNESS W8 to Harness
<2> ECU J8 to FADEC.
Выберите правильный вариант.
The runway was foamed as a precaution, but the plane landed without _____ trouble.
Выберите правильный вариант.
Use borescope ports B1-1 and B1-2 _____ B1-0 to look into these areas.
Выберите правильный вариант.
Corrosion that is inaccessible after the allowable cutback of the Kevlar is allowed _____ all other conditions of the repair are met.
Выберите правильный вариант.
_____ gear ratio differences between the accessory gearbox and the N2 rotor, stop the procedure at 265 degrees, and set the pointer back to zero degree.
Выберите правильный вариант.
An engine removal will be necessary _____ the tube supports are moved.
Вставьте глагол to include в правильной форме:
The activities of the certifying mechanic the limited rectification of defects and the capability to perform and certify minor scheduled line maintenance inspections, such as daily checks.
Вставьте глагол to start в правильной форме:
Clean the ramp area before the engine.
Вставьте глагол to have в правильной форме:
The GCU six fault indicator lights, one GCU PASS light and one test switch on the front panel.
Вставьте глагол to be в правильной форме:
If the coverplate is not installed, the fasteners are not correctly torqued, or the o-ring is not correctly installed, there a rapid oil loss to the engine.
Вставьте глагол to be в правильной форме:
Grease fittings should always cleaned before applying fresh grease.
Вставьте глагол to be в правильной форме:
There several ways to accomplish this including rubber cushion clamps, spiral wrap, cable ties and lacing cord.
Выберите правильный вариант.
If the fan _____ operated at speeds from 117.5% (3857 rpm) to 124.0% (4067 rpm), you must examine the engine.
Вставьте глагол to remove в правильной форме:
Make sure of the identity before the plugs near the aft end of the compressor stator case.
Вставьте глагол to have в правильной форме:
Loop A and B elements for each detector assembly the same equipment number.
Выберите правильный вариант.
If there _____ a fire in the engine (external or internal), remove the engine for disassembly and inspection (Ref GE Engine Manual).
Вставьте глагол to consist в правильной форме:
Modules of a low pressure turbine and a high pressure turbine.
Выберите правильный вариант.
If the number of cycles is unknown and there _____ two or more causes for the cooling air decrease, the engine can continue in service for 50 more flight cycles.
Вставьте глаголы to extract и to drive в правильной форме:
The accessory drive driving force from the high pressure compressor rotor engine-mounted accessories.
Вставьте глагол to obey в правильной форме:
If you the instructions, injuries to persons and damage to equipment can occur.
Вставьте глаголы to insert и to locate в правильной форме:
You do this step after and the probe in the engine.
Вставьте глагол to compress в правильной форме:
Ambient air in the compressor section.
Вставьте глагол to locate в правильной форме:
The combustion section in the compressor rear frame.
Вставьте глагол to fill в правильной форме:
Care must be taken when lubricating bearings and bearing surfaces with a grease gun to ensure that the gun with clean grease of the grade specified for the particular application.
Вставьте глагол to remove в правильной форме:
Install the fan blades in the fan disk positions from which it after the two coats of sprayable air drying lubricant have dried.
Вставьте глагол to do в правильной форме:
All metal removal must by hand operations.
Вставьте глагол to permit в правильной форме:
All of these cracks , if no material is gone.
Выберите правильный вариант:
On blades that have ______ leading edges, the blend may extend beyond the area where the tape was applied.
Выберите правильный вариант:
The local differences are _____ than the differences shown in Figure 807.
Выберите правильный вариант:
Do not use _____ than 350 pound-feet of torque on the hand cranking at the N” rotor or damage to the engine component can occur.
Выберите правильный вариант:
Hand wiping or brushing is the _____ method of cleaning areas containing these parts.
Выберите правильный вариант:
The _____ are operated through the nacelle fuel level transmitters during normal conditions.
Выберите правильный вариант:
Remove the _____ by removing the attaching hardware.
Выберите правильный вариант:
Make sure _____ is disconnected.
Выберите правильный вариант:
The ______ is installed to provide immediate alarm in the event of an engine compartment fire.
Выберите правильный вариант:
Open _____.
Выберите правильный вариант:
Install _____.
Выберите правильный вариант:
The _____ are mounted on a bracket in the control pedestal.
Выберите правильный вариант:
Protect damage from entrance of water, sunlight or other foreign matter by sealing with _____.
Выберите правильный вариант:
Oil outlet hose is below the external ______.
Вставьте правильный предлог:
Engine damage can occur if the borescope plugs are not installed the correct location.
Вставьте правильный предлог:
The case provides structural support the fan frame and the compressor rear frame.
Вставьте правильный предлог:
Put the flexible borescope, SPL-5661 port B1-6.
Вставьте правильный предлог:
Put the glass fabric, G51034 [C10-003] the damaged area.
Вставьте правильный предлог:
Inspect all electrically operated components and lightning systems damage.
Вставьте правильный предлог:
The coverplate location is difficult to see engine maintenance.
Вставьте правильные предлоги:
Because of gear ratio differences the accessory gearbox and the N2 rotor, stop the procedure 265 degrees, and set the pointer back zero degree.
Выберите правильный вариант.
This task provides the instructions on how to _____ crank the N2 rotor.
Выберите правильный вариант.
The N2 rotor does not turn _____.
Выберите правильный вариант.
If there is an _____ installation, the installation will cause a fast oil leakage.
Впишите правильный артикль (“a” или “an”)
When engine is installed on the wing after overhaul or replacement of significant number of fan blades, it is necessary that you first do vibration survey.
Выберите правильный вариант.
This inspection applies to PRE LEC and LEC Combustor configurations _____ specified otherwise.
Вставьте глагол to be в правильной форме:
If the Nitrogen cylinders are fully charged, you able to maintain the correct flow rates for the necessary length of time.